DriSteem Vapor-Logic Guide d'installation télécharger pdf (Page 11)

VAPOR-LOGIC

AUTO SCROLL INFORMATION

The following pages contain information about the digital read-outs that VAPOR-LOGIC

displays on the key pad. This

includes a wide variety of present system conditions, faults, and programmable parameters that ultimately control the

humidification system. The charts are organized based upon when or why the information is communicated.

Auto Scroll:

The items that will continuously scroll on the lower line during normal humidifier operation are listed below. The current

conditions are monitored and communicated through VAPOR-LOGIC

. The items available for individual review on the

upper line are noted.

12,73,5&6('//25&6278$

782'$(5//25&6278$

<$/36,'(1,/5(:2/

52)(/%$/,$9$

(1,/5(338

:(,9(5

tnioPteSytidimuHe

vitaleR"%__HRDERISED"ON

ytidimuHevitaleRlautcA"%__HRLAUTCA"SEY

ytidimuHtimiLhgiHmumixaM"%__HRLHXAM"ON

ytidimuH

timiLhgiHlautcA"%__HRLHTCA"SEY

erutarepmeTssalGwodniW"F__–PMETSSALG"SEY

tuptuOmetsySegatnecrePlatoT"%__DNAMEDSYS"ON

*yalpsiDegasseMecivreSlitnuemiT

)sruohni(

"H__ECIVRES"SEY

hsulFdnaniarDcitamotuAlitnuemiT

)sruohni(

"H__NIARDOTUA"SEY

niarDnosaeSfodnElitnuemiT

)sruohni(

"H__NIARDSOE"SEY

erutarepmeTtniopteS

noitcudeRnoitasnepmoC

"%__PMOCPMET"ON

* Clearing the Service Timer

1. Energize unit.

2. Once the unit has finished initializing, push the MODE

key until the display says STANDBY MODE.

3. Once in STANDBY MODE, push the SET button. If

the display says ENTER CODE, skip to step 7 now.

4. The display should now say SCAN TIME. Push the

SET button until the display says ACC CODE.

5. Push the 'Up Arrow' once to enter an access code

of 01. Press the MODE key.

6. After the display says SAVE MODE and returns to

the STANDBY MODE, press SET button again. The

display should now say ENTER CODE.

7. To reset the SERVICE Timer to the SERVICE

interval parameter value, a special Access Code

must be entered. Press the SET key to display the

ENTER CODE message. Use the UP and DOWN

keys to set the Access Code to '2345'. Press the

SET key a second time to enter the code. The

display will return to the AUTO MODE, but the

SERVICE Timer will be reset. The Access Code

parameter ACC CODE may be set to any non-zero

value and does not need to be set to the special

Reset Code.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

DriSteem Vapor-Logic Guide d'installation Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Déshumidificateurs DriSteem Vapor-Logic