DriSteem Vaporstream Spécifications télécharger pdf (Page 63)

VAPORSTREAM INSTALLATION, OPERATION, AND MAINTENANCE MANUAL

After the system is installed and connected properly:

1. Verify that the Vaporstream humidifier, controls, piping, electrical

connections, steam supply, and dispersion unit(s) are installed according to

the following:

• Installation instructions in this manual

• Vapor-logic version 5 Installation and Operation Manual

– Installation section

– Pre-installation checklist

• Ladder style wiring diagram (inside control cabinet)

• External connections wiring diagram (inside control cabinet)

• Heater connections wiring diagrams (inside heater terminal cover)

• All governing codes

2. Verify that electrical connections in the control cabinet and at the

humidifier are secure before applying power.

3. Make sure all electrical covers are in place and secure. See Warning at

right.

4. Verify that the humidifier is mounted level and securely supported before

filling with water. See operating weights in Table 6-1.

5. Verify that the humidifier is level front to back and side to side after it is full

of water.

6. Read the “Operation” section of the Vapor-logic version 5 Installation and

Operation Manual.

Note: During start-up, do not leave the humidifier unattended.

7. Perform all applicable “Start-up checklist” items. See Page 60.

8. Monitor humidifier operation through multiple fill cycles. The humidifier

operating status appears on the keypad/display.

9. On tap/softened water units, water skims from the humidifier after every fill

cycle. Adjust the amount of skim by increasing or decreasing the skim time

(see the Vapor-logic version 5 Installation and Operation Manual).

10. At start-up, DriSteem recommends initially running the humidifier with the

factory default setting for skim time. See “Maintenance,” beginning on

Page 61.

mc_060210_1400-VLC

The Vapor-logic version 5 Installation and

Operation Manual is a comprehensive

operation manual. Refer to it for information

regarding the following features:

• Keypad/display setup and menu information

• Control input signals and functions

• Drain, ﬂush, and skim features

• Safety features

• Alarm screens and fault messages

The manual was shipped with your

humidiﬁer and is available at our Web site:

www.dristeem.com

mc_052410_1340

OPERATION

Start-up procedure

WARNING

Electric shock hazard

Only qualiﬁed electrical personnel

should perform start-up procedure.

Contact with energized circuits can

cause property damage, severe

personal injury or death as a result of

electrical shock or ﬁre.

Make sure that all electrical covers

are in place and secure before turning

on electrical power. These include the

following:

• Heater terminal cover on tank

• Control cabinet door

CAUTION

Damage from dry startup

In the event the humidiﬁer tank does

not contain water and the heaters

are energized, turn main power off.

Operation of the heaters without water

will cause damage to the humidiﬁer.

Before turning main power on, verify

that all wiring has been completed per

the wiring instructions in this manual

and the unit wiring diagrams.

mc_052410_1325

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

DriSteem Vaporstream Spécifications Page 63

Commentaires sur ces manuels

Produits connexes et manuels pour Déshumidificateurs DriSteem Vaporstream