DriSteem HUMIDI-TECH DI Guide d'installation télécharger pdf (Page 34)

1BHFt%3*45&&.7BQPSMPHJD

Installation and Operation Manual

Temperature compensation transmitter placement

To place the temperature compensation transmitter, follow these

steps. See Figure 30-1 below.

1. Position the temperature compensation transmitter control box

on a wall adjacent to a window frame facing north or northeast.

2. Place flat surface of temperature sensor tip on lower corner of

glass surface.

3. Temporarily hold the sensor tip in place with strips of masking

tape.

4. Apply a small amount of clear RTV silicone adhesive over and

around the sensor tip (making sure the sensor tip is in contact

with the window glass).

5. After adhesive cures, remove masking tape.

8JSJOHTFOTPSEFWJDFTDPOUJOVFE

Thermostat

control wires

Surface-mounted

thermostat

temperature

control box on

wall

Typical

sensor cord

routing

Secure temperature sensor tip to

inside surface of window glass

using clear RTV silicone adhesive

Double pane

window glass

Window frame

OM-337

Figure 30-1:

Temperature compensation transmitter wiring

VL3_IOM.pdf 34 11/19/2009 9:11:13 AM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 107 108

Pas de commentaire

DriSteem HUMIDI-TECH DI Guide d'installation Page 34