DriSteem Vapor-Logic Guide d'installation télécharger pdf (Page 12)

Page 10 • DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual

L o c a t i o n a n d c l e a r a n c e

r e c o m m e n d a t i o n s

Locating the humidifier

• Provide a level, solid foundation for the humidifier.

• Locate the humidifier as near as possible to a chimney or

outside wall so that the flue pipe from the humidifier is

short and direct.

• Locate the unit so it and its electrical components are

protected from water during humidifier operation and

service.

• Install the humidifier in a location away (and protected)

from drafts. If installed in a separate room, follow the

instructions concerning combustion and ventilation air.

• Locate the humidifier in an area where leakage from the

tank or its connections will not result in damage to the

adjacent structure or to lower floors of the structure.

When such locations cannot be avoided, install a suitable

drain pan (adequately drained) under the humidifier. The

pan must not restrict combustion airflow.

• Do not install the humidifier on carpeting, tile or other

combustible material other than wood flooring (indoor

application only).

• If located in an insulated space, keep the humidifier free

and clear of insulating materials. Insulating material can

be combustible. Inspect the humidifier area when the

humidifier is installed or when insulation is added.

Figure 10-1:

GTS clearance recommendations

18" (457 mm)

36" (914 mm)

30" (762 mm)

OM-1222

Note:

DRI-STEEM recommends a minimum of 1" (25 mm) clearance between hot surfaces and

combustible walls.

Installation

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 79 80

Pas de commentaire

DriSteem Vapor-Logic Guide d'installation Page 12