DriSteem Vapor-Logic Guide d'installation télécharger pdf (Page 62)

Page 60 • DRI-STEEM GTS Humidifier Installation, Operation, and Maintenance Manual

GTS standard water quality recommendations

The best way to determine how often your particular system needs

maintenance is to remove the probe plate and inspect it for mineral

deposits after three months of duty. Potable water carries a variety

of minerals and other materials in a mix that varies from location

to location. This variation in water quality, combined with the

hours of operation and duty cycle, will determine your own unique

maintenance schedule.

Water quality makes a difference

• Light to moderately hard water (2 to 10 grains hardness per

gallon [35 mg/L to 170 mg/L]) requires:

– Annual cleaning

– Regular skimming

• High mineral content water (more than 10 grains hardness per

gallon [more than 170 mg/L]) requires:

– Cleaning frequency determined by use and water quality

– Regular skimming

– Periodic drain and flush cycles

• Softened water dramatically reduces mineral accumulation inside

standard water models.

(Note: Solids, like silica, are not removed in the softening

process.)

Adjusting skim duration

The skim time duration determines the quantity of water skimmed

with each fill cycle. Skim time is field adjustable using the

Vapor-logic4 keypad.

Each time the GTS refills, it fills to an elevation near the lip of the

skim/overflow fitting. A portion of the refill water then flows to the

drain carrying most of the minerals left by the previous evaporating

cycle. This reduces the mineral concentration, thereby reducing the

frequency of cleaning needed.

The heated water that flows to the drain is an operational cost.

Cleaning the humidifier also is an operational cost. Therefore,

DRI-STEEM recommends that the user observe and adjust the

skimming quantity to achieve a balance between minimizing

mineral buildup and conserving heated water.

M a i n t e n a n c e : G T S s t a n d a r d w a t e r

m o d e l s

Humidifier De-scaling solution

Scale buildup on humidifier heat exchangers

acts as an insulator, reducing humidifier

performance while increasing energy

costs. To keep humidifiers operating as

efficiently as possible, remove scale with

DRI-STEEM's Humidifier De-scaling Solution,

available for purchase from your DRI-STEEM

representative or distributor.

The De-scaling Solution cleans without risk

of corroding humidifier tanks or welds;

and there is no off-gassing, flammability,

or added heat risks associated with other

cleaning solutions. The De-scaling Solution

also cleans surfaces unreachable by hand

scraping.

DRI-STEEM's Humidifier De-scaling Solution

is the only approved cleaner/de-scaler for

use with DRI-STEEM humidifiers. Use of

other cleaners/de-scalers may void your

DRI-STEEM warranty.

mc_021908_1405

Maintenance

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

DriSteem Vapor-Logic Guide d'installation Page 62

Commentaires sur ces manuels

Produits connexes et manuels pour Déshumidificateurs DriSteem Vapor-Logic