DriSteem Vapor-logic3 Instructions d'exploitation télécharger pdf (Page 17)

Keypad/display installation.

Installation

Installation:

Keypad/display installation

Installing modular cable

IMPORTANT: When routing modular cable

inside the control cabinet, route cable away from all

power wiring and connect the male modular plug into

the VAPOR-LOGIC

printed circuit board-mounted

female modular receptacle, J2. Push male plug in

until you hear a “click.” (The cable should be

plugged into the keypad/display as well.) The six-

wire cable provides the AC power to the keypad/

display and completes the FTT-10A-type digital

communication between the keypad/display and the

VAPOR-LOGIC

control board.

CAUTION: If a longer cable is needed, do not

attempted to fabricate one. Improper wiring can

permanently damage the VAPOR-LOGIC

board,

keypad or display. Please contact your local

DRI-STEEM representative for longer cable options.

Installing the keypad/display

IMPORTANT: Do not locate the keypad/display

inside the control cabinet. The hardware is

premounted in the keypad/display case with front

access to the digital display and keypad. Position the

case in a convenient location for easy access.

Note that the keypad/display requires an ambient

temperature range of 32°F to 122°F (0°C to 50°C) to

operate properly. Exceeding these limits will result in

a poor reading or no reading at all.

We recommend that you mount the keypad/display to

a surface using a field-supplied network phone wall

plate. To mount, simply slide the keypad/display onto

the tabs on the phone plate.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 74 75

Pas de commentaire

DriSteem Vapor-logic3 Instructions d'exploitation Page 17