DriSteem Vapor-logic3 Instructions d'exploitation télécharger pdf (Page 50)

Drain and flush options

VAPOR-LOGIC

is preprogrammed to enter an

automatic drain, flush and refill cycle to help keep

mineral concentrations in the tank to a minimum. The

method by which this is accomplished is selected by

the user through the keypad/display in the Set Up

screen. The three options available are:

1.Flush after usage

2. Flush at a certain time after usage, and

3. Flush at a certain time

Please note that these options are only available with

a standard water system having an automatic drain

valve. If the humidifier is configured for DI/RO

water, or if the unit has a manual drain valve, these

drain and flush options are not available.

In the flush after usage mode, the humidifier will

enter the drain and flush sequence after a user-

selected amount of water has been converted to

steam. In other words, if the user set the drain and

flush interval to 10,000 pounds, the unit will enter the

drain and flush sequence the moment 10,000 pounds

of water have been boiled.

In the flush at a certain time after usage mode, the

humidifier will enter the drain and flush sequence at

a specific time after a user-selected amount of water

has been converted to steam. In other words, if the

user sets the drain and flush interval to 10,000

pounds and the ADS Hour to 2, the unit will enter the

drain and flush sequence at 2:00 am after 10,000

pounds of water have been boiled. This allows the

user to keep the humidifier on line until a convenient

time for the drain and flush sequence.

Operation:

Drain and flush, skim

Drain and flush, skim.

Operation

In the flush at a certain time mode, the humidifier will

enter the drain and flush sequence at a specific time,

ignoring the amount of water that has been converted

to steam. In other words, if the user sets the ADS

Hour to 2, and the ADS Interval to 7 days, the unit will

enter the drain and flush sequence every 7 days at

2:00 am.

When VAPOR-LOGIC

initiates the drain and flush

sequence, all activated heat sources are deactivated.

The drain valve is then opened to allow the tank to

drain. The drain valve remains open during the flush

sequence for drainage while the fill valve is open. At

the completion of the flush cycle, the drain valve

closes allowing the fill valve to refill the tank. For

multiple tank systems, only one tank at a time enters

the drain and flush sequence in order to keep as much

capacity available as possible.

Skim timer

With a standard water configuration, the

VAPOR-LOGIC

controller comes equipped with a

skim timer. This timer is activated at the end of each

fill cycle. The timer keeps the fill valve open for a

user-determined amount of time after the tank has

filled to skim minerals off the water surface. The

skim time is adjusted through the Set Up screen on

the keypad/display.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 74 75

Commentaires sur ces manuels

Pas de commentaire

DriSteem Vapor-logic3 Instructions d'exploitation Page 50

Commentaires sur ces manuels

Produits connexes et manuels pour Déshumidificateurs DriSteem Vapor-logic3